AC Generator & Transformer
A transformer is used to light a 100 W and 110 V lamp from a 220 V mains. If the main current is 0.5 amp, the efficiency of the transformer is approximately
Show answer
Answer: (b)
Full solution and similar questions →These are the 47 physics questions of NEET 2007 (AIPMT) that are in the Physics Circle question bank, arranged chapter by chapter. Tap an option to check your answer; every question links to its full solution.
AC Generator & Transformer
A transformer is used to light a 100 W and 110 V lamp from a 220 V mains. If the main current is 0.5 amp, the efficiency of the transformer is approximately
Answer: (b)
Full solution and similar questions →AC Generator & Transformer
The primary and secondary coils of a transformer have 50 and 1500 turns respectively. If the magnetic flux linked with the primary coil is given by 0 + 4t, where is webers, t is time in seconds and 0 is a constant, the output voltage across the secondary coil is
Answer: (a)
Full solution and similar questions →Resonance, Bandwidth & Q Factor
What is the value of inductance L for which the current is maximum in a series LCR circuit with C = 10 F and = 1000 s?
Answer: (d)
Full solution and similar questions →Energy of the Electron & Energy Levels
The total energy of electron in the ground state of hydrogen atom is 13.6 eV. The kinetic energy of an electron in the first excited state is
Answer: (d)
Full solution and similar questions →Quantum Numbers, X-rays & Other Questions
In a mass spectrometer used for measuring the masses of ions, the ions are initially accelerated by an electric potential and then made to describe semicircular paths of radius R using a magnetic field B. If V and B are kept constant, the ratio will be proportional to
Answer: (a)
Full solution and similar questions →Combination of Capacitors
Two condensers, one of capacity C and other of capacity C/2 are connected to a V-volt battery, as shown in the figure. The work done in charging fully both the condensers is

Answer: (b)
Full solution and similar questions →Electrical Power & Heating Effect
A steady current of 1.5 amp flows through a copper voltameter for 10 minutes. If the electrochemical equivalent of copper is , the mass of copper deposited on the electrode will be
Answer: (c)
Full solution and similar questions →Electrical Power & Heating Effect
If the cold junction of a thermocouple is kept at and the hot junction is kept at , then the relation between neutral temperature and temperature of inversion is
Answer: (d)
Full solution and similar questions →Electrical Power & Heating Effect
The total power dissipated in watt in the circuit shown here is

Answer: (b)
Full solution and similar questions →Wheatstone Bridge & Metre Bridge
Three resistances, P, Q, R each of 2 and an unknown resistance S from the four arms of a Wheatstone bridge circuit. When a resistance of 6 is connected in parallel to S the bridge gets balanced. What is the value of S?
Answer: (a)
Full solution and similar questions →Cathode Rays, Thomson's Experiment & Gas Discharge
A beam of electron passes undeflected through mutually perpendicular electric and magnetic fields. If the electric field is switched off, and the same magnetic field is maintained, the electrons move
Answer: (a)
Full solution and similar questions →Photoelectric Experiment: Intensity, Stopping Potential & Graphs
A 5 watt source emits monochromatic light of wavelength 5000 . When placed 0.5 m away, it liberates photoelectrons from a photosensitive metallic surface. When the source is moved to a distance of 1.0 m, the number of photoelectrons liberated will be reduced by a factor of
Answer: (d)
Full solution and similar questions →Photons: Energy, Momentum & Radiation Pressure
Monochromatic light of frequency 6.0 1014 Hz is produced by a laser. The power emitted is 2 103 W. The number of photons emitted, on the average, by the source per second is
Answer: (d)
Full solution and similar questions →Nature of EM Waves & Wave Equation
The electric and magnetic field of an electromagnetic wave are
Answer: (c)
Full solution and similar questions →Electric Field & Field Lines
Three point charges +q, 2q and + q are placed at points (x = 0, y = a, z = 0), (x = 0, y = 0, z = 0) and (x = , y = 0, z = 0) respectively. The magnitude and direction of the electric dipole moment vector of this charge assembly are
Answer: (a)
Full solution and similar questions →Electric Flux & Gauss's Law
A hollow cylinder has a charge q coulomb within it. If is the electric flux in units of volt-metre associated with the curved surface B, the flux linked with the plane surface A in units of V-m will be

Answer: (d)
Full solution and similar questions →Electrostatic Potential Energy
Charges +q and q are placed at points A and B respectively which are a distance 2L apart, C is the midpoint between A and B. The work done in moving a charge + Q along the semicircle CRD is

Answer: (c)
Full solution and similar questions →Satellites - Orbital Velocity & Period
Two satellites of earth, S1 and S2 are moving in the same orbit. The mass of S1 is four times the mass of S2. Which one of the following statements is true?
Answer: (b)
Full solution and similar questions →Friction Basics
A block B is pushed momentarily along a horizontaly surface with an initial velocity V. If is the coefficient of sliding friction between B and the surface, block B will come to rest after a time

Answer: (d)
Full solution and similar questions →Bar Magnet & Magnetic Moment
A charged particle (charge q) is moving in a circle of radius R with uniform speed v. The associated magnetic moment is given by
Answer: (d)
Full solution and similar questions →Magnetic Materials & Curie Law
Nickel shows ferromagnetic property at room temperature. If the temperature is increased beyond Curie temperature, then it will show
Answer: (d)
Full solution and similar questions →Distance, Displacement & Average Speed
A car moves from X to Y with a uniform speed vu and returns to X with a uniform speed vd. The average speed for this round trip is
Answer: (d)
Full solution and similar questions →Velocity, Acceleration & Variable Motion
The position x of a particle with respect to time t along x-axis is given by x = 9t2 t3 where x is in metres and t in seconds. What will be the position of this particle when it achieves maximum speed along the + x direction?
Answer: (a)
Full solution and similar questions →Velocity, Acceleration & Variable Motion
A particle moving along x-axis has acceleration f, at time t, given by f = f0 where f0 and T are constants. The particle at t = 0 has zero velocity. In the time interval between t = 0 and the instant when f = 0, the particle's velocity (vx) is
Answer: (c)
Full solution and similar questions →Moving Charge in a Magnetic Field
Under the influence of a uniform magnetic field, a charged particle moves with constant speed v in a circle of radius R. The time period of rotation of the particle
Answer: (b)
Full solution and similar questions →Moving Coil Galvanometer, Ammeter & Voltmeter
The resistance of an ammeter is 13 and its scale is graduated for a current upto 100 amps. After an additional shunt has been connected to this ammeter it becomes possible to measure currents upto 750 amperes by this meter. The value of shunt-resistance is
Answer: (a)
Full solution and similar questions →Law of Radioactive Decay
Two radioactive substances A and B have decay constants 5 and respectively. At t = 0 they have the same number of nuclei. The ratio of number of nuclei of A to those of B will be (1/e)2 after a time interval
Answer: (c)
Full solution and similar questions →Mass Defect & Binding Energy
A nucleus has mass represented by M(A, Z). If Mp and Mn denote the mass of proton and neutron respectively and B.E. the binding energy in MeV, then
Answer: (a)
Full solution and similar questions →Nucleus: Composition, Size & Nuclear Force
If the nucleus has a nuclear radius of about 3.6 fm, them would have its radius approximately as
Answer: (d)
Full solution and similar questions →Radioactive Decays: Alpha, Beta, Gamma
In a radioactive decay process, the negatively charged emitted -particles are
Answer: (a)
Full solution and similar questions →Energy in SHM
The particle executing simple harmonic motion has a kinetic energy K0cos2t. The maximum values of the potential energy and the total energy are respectively
Answer: (c)
Full solution and similar questions →Periodic Motion & SHM Basics
A particle executes simple harmonic oscillation with an amplitude . The period of oscillation is T. The minimum time taken by the particle to travel half of the amplitude from the equilibrium position is
Answer: (b)
Full solution and similar questions →Velocity & Acceleration in SHM
The phase difference between the instantaneous velocity and acceleration of a particle executing simple harmonic motion is
Answer: (d)
Full solution and similar questions →Velocity & Acceleration in SHM
A mass of 2.0 kg is put on a flat pan attached to a vertical spring fixed on the ground as shown in the figure. The mass of the spring and the pan is negligible.
When pressed slightly and released the mass executes a simple harmonic motion. The spring constant is 200 N/m. What should be the minimum amplitude of the motion so that the mass gets detached from the pan (take g = 10 m/s2).

Answer: (a)
Full solution and similar questions →Motion in a Plane (2-D Kinematics)
A particle starting from the origin (0, 0) moves in a straight line in the (x, y) plane. Its coordinates at a later time are . The path of the particle makes with the x-axis an angle of
Answer: (b)
Full solution and similar questions →Total Internal Reflection
A small coin is resting on the bottom of a beaker filled with liquid. A ray of light from the coin travels upto the surface of the liquid and moves along its surface. How fast is the light travelling in the liquid?

Answer: (d)
Full solution and similar questions →Angular Momentum & its Conservation
A particle of mass m moves in the XY plane with a velocity v along the straight line AB. If the angular momentum of the particle with respect to origin O is LA when it is at A and LB when it is at B, then

Answer: (a)
Full solution and similar questions →Rotational Kinematics & Dynamics
A wheel has angular acceleration of 3.0 rad/sec2 and an initial angular speed of 2.00 rad/sec. In a time of 2 sec it has rotated through an angle (in radian) of
Answer: (a)
Full solution and similar questions →Rotational Kinematics & Dynamics
A uniform rod AB of length and mass m is free to rotate about point A. The rod is released from rest in the horizontal position. Given that the moment of inertia of the rod about A is ml2/3, the initial angular acceleration of the rod will be

Answer: (c)
Full solution and similar questions →Intrinsic & Extrinsic Semiconductors
In the energy band diagram of a material shown below, the open circles and filled circles denote holes and electrons respectively. The material is
![]()
Answer: (d)
Full solution and similar questions →Junction Transistor
A common emitter amplifier has a voltage gain of 50, an input impedance of and an output impedance of . The power gain of the amplifier is
Answer: (b)
Full solution and similar questions →Logic Gates
In the following circuit, the output Y for all possible inputs A and B is expressed by the truth table.
![]()
Answer: (c)
Full solution and similar questions →Other / Mixed
For a cubic crystal structure which one of the following relations indicating the cell characteristics is correct?
Answer: (c)
Full solution and similar questions →Heat Engines, Refrigerators & Second Law
An engine has an efficiency of 1/6. When the temperature of sink is reduced by 62oC, its efficiency is doubled. Temperatures of the source is
Answer: (c)
Full solution and similar questions →Units & Dimensions
Dimensions of resistance in an electrical circuit, in terms of dimension of mass M, of length L, of time T and of current I, would be
Answer: (c)
Full solution and similar questions →Wave Theory, Wavefronts & Doppler Effect
The frequency of a light wave in a material is 2 1014 Hz and wavelength is 5000 . The refractive index of material will be
Answer: (b)
Full solution and similar questions →Spring & Elastic Energy
A vertical spring with force constant k is fixed on a table. A ball of mass m at a height h above the free upper end of the spring falls vertically on the spring so that the spring is compressed by a distance d. The net work done in the process is
Answer: (a)
Full solution and similar questions →